We are providing OEM services for our competitors from European country and Janpan company.KingJime is a pressional factory of cut to length line, slitting line , pipe making machine and 3 in 1 feeder and so on

Straightening machines today fall into two basic categories, the most common of which are known as "straighteners" or "flatteners". This arrangement is generally available in models with between 5 and 11 work rolls. The roll diameters and center distances vary depending on material thickness and width but straighteners and flatteners are generally distinguished by fairly large diameter, widely spa...

Failure and Solution in 3 in 1 compact feeder.Feeding error and only a fixed direction 1.Pressure is not enough from feeding rollersIncrease pressure2.Feeding length is too long.Shorten the feeding length 3.Feeding material is not enough.Inspect material width and position of guiding board on the die. 3 in 1 Machine and punch tools should be in line.4.There is some waste on the punch toolsSee if ...

1.push the button coil car forward and backward. Load the coil on the coil car.2.operate the decoiler mandrel to collapse the smallest. 3.push the button coil car lifts the coil up until the core of the coil is the line of the decoiler mandrel, and operate the coil car move to the coil to the decoiler mandrel. 4.push the button decoiler expansion, the decoiler expand the coil. Note: In the coil lo...

How to use the automatic decoiler which made by kingjime company to feed material?1.Uncoiler has been set to standard in our factory: When metal coil strip touches the sensor rod, machine will stop at once. When coil leaves the sensor rod for a few minutes (sensor time), the machine will start to work. 2.The Sensor time set short or long affects to the operating and service life for machine. You c...